Excavator attachment supply · Ningbo, China Search · FAQ · Support · Market / EnglishWhatsApp +86 15058273161
WE-ATTACH

WE-ATTACH / EXCAVATOR ATTACHMENTS

From a hole requirement to an auger configuration

From a hole requirement to an auger configuration. Review the task, configuration and source information before ordering.

WE-ATTACH source-led buying guide · Updated 2026-11-17 · Project and technical approval are separate from this guide.

From a hole requirement to an auger configuration — supplied Auger Drives family reference images.
Illustrative guide layout using supplied product-family photographs; exact models, interfaces and scope require configuration review.

Use this guide to organize the supplied product information around the purchasing task. The exact model, machine and approved configuration remain part of project review.

Describe the hole first

Record required hole diameter/depth, ground description, access and the proposed machine. Keep the soft/medium/hard brochure labels as source reference categories rather than measured geotechnical specifications.

Connect the components

Compare drive output shaft, auger, extension and ground tool as a proposed set. The supplied auger guide has four ground-tool and wear-part pages after the drive models.

Read the drive record

Keep flow, pressure, torque, dimensions and referenced depth conditions with the exact drive model. Separate maximum values do not establish one operating point. Source conflicts such as WD5 dimensions remain open until the current drawing is confirmed.

Prepare the project enquiry

Send machine identity and circuit data, mounting/output interface, hole/ground requirements, proposed tooling, quantity and destination. Ask for the model-specific drawing and applicable operating information.

Source and document traceability

Catalogue transcription for preliminary review. Confirm the applicable configuration and current approved revision before order.

Related applications

Model references

CONTINUE YOUR REVIEW

Related information for your next decision

Discuss your machine, application and configuration →

What do you need to do?

Start with part of a model or describe the job. Suggested results are for selection review.